Master-force 241-0431 Instrukcja Operatora Pobierz pdf (Strona 14)

GENERAL CUTTING (Fig. 6a and 6b)

WARNING! Before attaching

the battery pack on the tool, always

check to determine that the switch

performs properly and returns to the

“OFF” position when released.

WARNING! Hold the tool only by

the plastic handle and the insulated

grip area to help prevent electrical

shock. When sawing into walls or

ﬂoors you may encounter electrical

wiring. Sawing into a “live” wire will

cause electric shock.

1. Make sure that the workpiece is

ﬁrmly clamped.

2. Use the appropriate type and

size of blade for the workpiece

material and size.

3. Check for clearance behind the

workpiece so that the blade will

not impact another surface.

4. Mark the line of cut clearly. If

cutting metal, apply cutting oil on

the line.

5. Hold the saw ﬁrmly with one hand on the insulated gripping surface. Do

not use two hands with this saw (Figs 6a and 6b).

6. Depress the lock-off button and trigger switch to start the saw and bring

it to the maximum desired cutting speed before applying the blade to the

workpiece.

7. With the shoe ﬁrmly on the workpiece, apply the blade to the workpiece

and begin the cut.

8. Do not force the tool. Place the shoe ﬁrmly on the workpiece while

cutting. Use only enough steady pressure on the blade to keep the saw

cutting.

9. Reduce pressure as the blade comes to the end of the cut.

10. Allow the saw to come to a complete stop before removing the blade from

the workpiece.

11. If sawing ﬁberglass, plaster, wallboard, or spackling compound, clean

the saw motor vents frequently with a vacuum or compressed air. These

materials are highly abrasive and may accelerate the wear on motor

bearings and brushes.

Fig. 6a

Fig. 6b

1 2 ... 9 10 11 12 13 14 15 16 17 18 19

Komentarze do niniejszej Instrukcji

Brak uwag

Master-force 241-0431 Instrukcja Operatora Strona 14

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Elektronarzędzia Master-force 241-0431